secondary alloy
英 [ˈsekəndri ˈælɔɪ]
美 [ˈsekənderi ˈælɔɪ]
网络 再生合金; 二次合金
双语例句
- Study of Secondary Cooling for Alloy Steel Billet Continuous Casting
合金钢方坯连铸机二次冷却制度的研究 - Secondary air tuyere: aluminum alloy shutter, the surface was electro-sprayed by epoxy resin.
补风口：采用铝合金百叶窗，表面环氧树脂喷涂。 - Formation and Evolution of Secondary Phases in A Nb-W-Mo-Zr-C Alloy
Nb-W-Mo-Zr-C高温合金中第二相的形成演化与力学性能 - Design and application of secondary cooling water dynamic control system for bloom caster of alloy steel
合金钢矩形坯铸机动态二冷配水在线控制系统的设计与应用 - The results reveal that the solidification rate has a noticeable influence on the effect of modification of rare earth on eutectic Si phase. Rare earth can decrease the α( Al) secondary dendrite arm spacings and increase the cast hardness of this alloy.
结果表明，凝固速度显著影响稀土对共晶硅相的变质效果，稀土减小α（Al）二次枝晶间距，并使合金铸态硬度提高。 - Main Elements of Secondary Blowhole in Silicon and Aluminum Alloy
影响铝硅合金中二次气孔的主要因素 - θ phase and Cr phase were dissolved into α( Al) solid-solution and secondary dispersed T phase can be precipitated from the T6 treated alloy. Meanwhile, there exist laminar Al_3 Ti segregation and retained Al_2Cu phase in crystal boundary.
T6固溶处理时，θ相和Cd相溶入α固溶体中，二次T相呈弥散小质点析出，组织中还存在片状Al3Ti的偏析物和未完全溶解残留在晶界上的Al2Cu相。 - The internal quality of the casting pipe can be controlled by choosing and controlling the chemical composition stringently, improving the remained magnesium moderately to prevent nodulizing degradation, adopting the first and secondary inoculation and choosing Si-Ba alloy as the third instantaneous inoculation.
通过选择和严格控制化学成分，适当提高残留镁量，防止球化衰退，采用一次孕育、2次孕育和选用硅钡合金瞬时孕育的三次孕育，确保铸管内在质量。 - It was found that a cobalt-based solid solution with a face-centered cubic crystal structure is presented accompanied by the secondary phase M_7C_3 with a hexagonal crystal structure in the cobalt-based alloy coating.
结果表明，堆焊合金层主要是由面心立方的γ（Co）和六方结构的M7C3构成，并且在钴基固溶体中存在着许多堆垛层错。 - It was found that rapid quenching eliminates the secondary phase in the as cast alloy. An amount of amorphous phase is formed in the quenched alloy.
发现快淬态合金基本上消除了第二相，快淬合金组织中存在一定比例的非晶相，并且随着淬速增加非晶相的量增多； - Coarsening kinetics of multi-component m_2c precipitates in secondary hardening alloy steels
二次硬化合金钢中多组元强化相M2C碳化物的粗化动力学研究 - Three theory models about secondary arm spacing were summarized in the paper. The experimental results were presented on the secondary arm spacing in Cu-Zn alloy.
本文中概述了3种二次枝晶臂间距理论模型，介绍了对CuZn合金二次臂间距的实验结果。 - Adding certain secondary precipitated phase forming alloying elements in Cu casting alloy, such as Cr, in comparsion with solid solution forming alloying elements for the crystalizer can remarkably improve its creep resistance at high temperature.
在结晶器铸铜合金中添加能析出第二相质点的元素，与添加固溶型元素相比较能明显提高其高温抗蠕变性能。 - The precipitation mechanism of secondary η phase in a FeNi-based alloy
Fe-Ni基合金中次生η相的析出机理 - It is because there exists Mg-contained LaNi_3 phase as secondary phase which improves the electrochemical catalytic activity of alloy particles surface and the structure toughness of alloy particles.
主要原因是由于LaNi3第二相的生成不仅提高了合金颗粒表面的电化学催化活性，而且提高了结构韧性从而抵消了低钴合金颗粒粉化的不利影响。 - Secondary cooling technology for vanadium micro-alloy rail steel
含钒微合金化重轨钢连铸二冷技术的研究 - Honda Uses Secondary Aluminum Alloy to Make Motorcycle Frame
本田利用再生铝合金制造摩托车车架 - On the basis of the previous paper [ 1], dislocation structures in the primary and secondary stages of high temperature creep of a nickel base alloy ( Ni80Cr20Ti) have been studied by transmission electron microscopy.
本文在文献[1]的基础上，用电子显微镜透射方法研究了一种镍基合金（Ni80Cr20Ti）在高温蠕变第一和第二阶段内的位错结构。 - Mechanism of secondary electron emission of cu-al-mg alloy
Cu-Al-Mg合金的次级电子发射机理的探讨 - Determination of Rhodium in Secondary alloy by Catalytic Polarography
催化极谱法测定二次合金中的铑 - With IAS 4 Image Analysis System, the distances between secondary dendrites in the structures of Co based alloy coatings, laser surface melt cast on the high temperature alloys with different contents of rare earth, were determined. Qualitative analysis of the effect regularities was made.
用IAS－4图像分析系统定量地测定了高温合金激光表面熔铸Co基合金涂层添加不同稀土含量的组织中二次枝晶间距变化，并对其影响规律作了定性分析。 - The high-antimony alloy, regular low-antimony alloy and secondary lead Low-antimony alloy have been compared in different experiments.
对高锑合金、普通低锑合金、再生铅低锑合金进行了对比试验与讨论。 - Some new secondary phases precipitates after hot deformation. The mechanical properties of the alloy after deformation treatment are improved.
合金在变形处理后有新的第二相析出，且合金的力学性能有很大提高。 - Effect of Chill on Secondary Dendrite Arm Spacing of Aluminum Alloy Casting
冷铁对铝合金铸件二次枝晶间距的影响 - Advance in Research of Tempering Secondary Hardening of Alloy Tool and Die Steel Fe-M-C Quenched Martensite
合金工模具钢Fe-M-C淬火马氏体回火的二次硬化研究进展 - The directional solidification method was used to investigate the secondary dendrite arm spacing of primary austenite of hypoeutectic Fe-C-Si-Mn alloy with various antimony contents.
采用定向凝固方法研究了不同锑含量的亚共晶Fe－C－Si－Mn合金初生奥氏体二次枝晶臂间距。